2 Fog Planes in 1 map?

[fatso784]

I'm really confused on how to get 2 water fog planes(fog from B30) in 1 map. The main base is a dam, and there is a stream flowing out from a crack in the wall on one side, while on the other there is a giant lake. As you can see, I need the water level to be higher on one side. This poses quite a dilemna to me -.-

If any of you could give me advice, I'd really appreciate it.

[Ki11a_FTW]

i just make boxes instead of planes. that way the fog stays in that area

[fatso784]

i just make boxes instead of planes. that way the fog stays in that area

I apologize for being a noob but: You can do that? Oo

[fatso784]

I tried what you said EP_Killa, but I still get the "two fog planes intersected" error, so I still need to figure out how to make 2 water fog planes of different levels on each side of a dam wall. Does anyone else have any suggestions? It's really the onlly thing holding me back from completing this map.

[Ki11a_FTW]

detach each side of the box, and move them away from each other A LITTLE

[fatso784]

You mean delete the sides of the box, so only the top and bottom faces remain, essentially having 2 planes on either side of the map? ill try that.

[Roostervier]

I tried what you said EP_Killa, but I still get the "two fog planes intersected" error, so I still need to figure out how to make 2 water fog planes of different levels on each side of a dam wall. Does anyone else have any suggestions? It's really the onlly thing holding me back from completing this map.

I have never heard of that box method before either. If you plan on using more than one very near each other, I suggest you learn how to make portals really well, as you cannot have more than one fog plane per portal.

[fatso784]

Yeah I have never really tried portals but I was thinking of portaling each side of the map so the fog would only go so far, but I'm still not exactly sure thatll work either. The fogs are separated by a wall, but in halo I dont think that matters, itll still give the error. I'll try Killa's method and then look into portaling if that doesnt work.


EDIT: Thanks alot flyinrooster portaling the map worked!! EDIT: Sorta..........

EDIT #2: The structure and lightmaps compile, but the fog still only appears in 1 fog region. How can I change the fog in the 2nd fog region? -->

[kenney001]

use k00rnman's gurilla mb? IDK i have never tried it...

[Ki11a_FTW]

agh, you guys dont understand