ATTN: M1913 RAILS - Do it right, use refs

[Corndogman]

Ross (and Snaf), no offense, but I'll be honest here. Your guys' last couple of post just come off sounding like "I know shit about military shit, your wrong, I'm always right and your fucking stupid. etc. etc."

Your post always sound like this and it gets pretty fucking annoying. You don't realize it, but what if someone started telling you the same thing about a different subject, telling you that your an idiot and that they know everything about such and such. You would be annoyed.

Maniacs question was simple and completely valid. You could have just answered "the decreased resolution fuxed it a little, its the same" This little argument would have never happened, but you guys always have to make a big deal out of it and always be the one who's right all of the time. Just chill the fuck out.

awaiting -rep, but hell, this is my honest opinion so who cares.

[SnaFuBAR]

Too fucking bad.

[Roostervier]

It's just funny, because personally I think it would come across as annoying to them (and me) that someone who didn't know what he was talking about brought up moot points and insisted that he was right. Especially considering they know so much more about guns and rails than he does.

[Maniac]

I am never against saying i was wrong, and i was, to post my 2nd post after it was answered already.
But i really just had a question about the 2 pics (that looked so different to me).

[rossmum]

It's just funny, because personally I think it would come across as annoying to them (and me) that someone who didn't know what he was talking about brought up moot points and insisted that he was right. Especially considering they know so much more about guns and rails than he does.

mutual annoyance

a terrible, terrible thing

[Warsaw]

STANAG 2324 and Weaver are both 20mm, right?

[SnaFuBAR]

stanag 2324 and m1913 are the same exact thing. Spacing on a weaver is different than on an m1913 rail. 20mm in what regards?

[PenGuin1362]

Hey I'm an asshole to ya know

Also this shouldn't be a sticky for just rail refs, but refs in general and knowing how to properly study the refs to make an accurate model, not half assing it.

[Pooky]

Hate to poke my dick into an already resolved argument buuuut

They are the same. You just don't know how to read blueprint measurements and tolerances.

He gave you as clear an answer as possible

I am pretty sure they are not the same, there is a 90 degree angle in the other pics, there is not detailed breakdown of that area that i can see and no explaination of a 90 either.

and you continued to argue

So you got shot down. No excuse for the hissy fit.

[Warsaw]

stanag 2324 and m1913 are the same exact thing. Spacing on a weaver is different than on an m1913 rail. 20mm in what regards?

The width of the rail from edge to edge.

Me = not well versed in modern Western weapons.